Drain Lining – No Dig Technology

No Dig Technology is a proven and established method of placing a new pipe within an existing damaged pipe without excavation and with minimal disruption.

The new pipe material is similar to GRP (glass reinforced plastic) and in all cases will be superior in quality and strength to the pipe which it lines. The new pipe is moulded into the damaged pipe by an ingenious method called ‘inversion’ using water or air pressure, fitting it tightly against the wall of the existing pipe. When the inversion is complete the new pipe (which is originally flexible) is now rigid, resulting in a strong, tough pipe tightly fitted within the existing pipe with only a minimum loss of cross section of approximately 6%.

The liner is manufactured from a special dense impermeable felt and is designed and tailored to fit exactly the internal dimension of the pipe to be refubished. The thickness of the lining material can be varied according to design specifications required.

We have a selection of three special resins systems – Polyester, Silicate and Epoxy with different curing times – suitable for various conditions and applications. These are impregnated into the liner prior to installation in the pipe.

The liner is suitable for sewers and vertical rainwater down pipes etc, 75mm – 300mmØ. It is resistant to most aggressive chemicals and can withstand extremely high temperatures.

A special resin containing an activating catalyst is impregnated into the pipe liner prior to installation.

Drain lining is suitable for sewers and vertical rainwater downpipes etc, 75mm – 300mØ. The liner is resistant to most aggressive chemicals and can withstand extremely high temperatures.

Once the pipe is cured, the inversion liner is removed leaving a strong and tough new pipe within the existing pipe. Any lateral pipes are reconnected by a remote controlled robotic cutter.

Benefits of No Dig Technology

  • Eliminates costly excavations and general disruption to the property.

  • Capable of repairing and curing leaking and open joints, root intrusion, cracks and all other associated pipe failure.

  • The process is accepted by Local Authorities, Loss Adjusters, Surveyors, Civil Engineers and Architects etc.

  • Achieves permanent structural repair.

  • Guarantees improved flow characteristics.

  • Will withstand ground movement far in excess of traditional drainage materials such as saltglaze, clayware, concrete etc.

  • Any cross-sectional loss is adequately compensated by increased flow efficiency.

  • Suitable for domestic, industrial, commercial and municipal applications.

  • Continual lengths of up to 100 metres can be installed in one length.

  • Minimum lengths of 0.5 of a metre can be installed for a local structural repair.

  • The materials used are extremely strong, abrasive resistant and do not rely on the existing pipe for its structural integrity.

  • A drain liner refurbishment will be ready for use within hours of installation.

  • Very cost effective, up to 75% savings have been achieved by drain lining over conventional methods.

  • Superior quality at lower cost means good value for money. The drain liner we use (Renoline) conforms with European Standard BSEN13566-F:2002.